You'll need:
- Your Juniper Cardigan neckband pieces (either the long line or cropped version, which ever you're making).
- Interfacing pieces
- Sewing machine with needle & thread
- Iron
Steps:
1. Interface the wrong side of both neckband pieces, starting at the bottom of each neckline piece and matching notches.
Note: Always test your interfacing on a scrap of fabric first! If you're not sure about knit interfacing, check out this post.
2. Right sides together, matching double centre back notches, stitch neckline pieces together. Press seam open and trim down seam allowances.
3. At each end of your neckband piece (the interfaced ends), right sides together, fold in half and stitch down. Trim down seam allowances and notch corners.
4. Turn neckband out to the right side, gently poking out the bottom corners. Press.
5. Press the entire neckband piece in half, wrong sides together, matching notches.
Next up, attaching those sleeves!
xx
J
Post Comment
Post a Comment
Thank you so much for stopping by to leave me a comment, like most people, I really do appreciate them all!
Due to the large amount of spam I receive here, unfortunately I have had to turn comments off. If you'd like to get in touch with me, please send me an email :)
Note: Only a member of this blog may post a comment.